151
Technical Advice and Questions / Re: Looking For Upgraded Axle
« on: October 13, 2008, 10:03:10 pm »
Im still new at the Jeep thing, what Axle is the 8 1/4? And what gears do the the D-35's have?
News:
April 2024 Club Meeting
2nd SUNDAY / April 14, 2024 / 11am
*******Located at the York Regional Parks building****
25 Oak Street, York, Pa
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
152
Technical Advice and Questions / Looking For Upgraded Axle
« on: October 13, 2008, 09:30:09 pm »
Im looking to upgrade the D-35 on my Cherokee to a better one. I have 31's on my Cherokee, and I have always had a little bump in the back (more like the back is dogging out the faster I go down the road) and Im getting tired of it. I was told by a few friends that the D-35 is NO good for Jeeps with 31's or bigger. Due to the weight. So Im looking to upgrade the back Axle, but would I need to replace the front one also? Im not sure what my front axle is.
But I was wondering what to replace my axles with. Seeing as how this is still my first Jeep, and Im still learning.
But I was wondering what to replace my axles with. Seeing as how this is still my first Jeep, and Im still learning.
153
Technical Advice and Questions / Re: Three questions for the gang...
« on: August 13, 2008, 12:41:44 pm »154
Technical Advice and Questions / Re: New Radiator to be installed, what else should be done at the same time?
« on: July 04, 2008, 11:50:00 pm »
The shroud helps direct the cool air right into your radiator, without it the air just kinda blows everywhere.
155
Technical Advice and Questions / Re: Found Something Instresting
« on: April 30, 2008, 10:58:59 pm »
No its not an O2 sensor, it looks like a plug that would fit in the side of the motor or axels, it has a rubber piece toward the end that looks like a plug/stopper so when you insert it into a hole it doesn't pull out.
156
Technical Advice and Questions / Found Something Instresting
« on: April 30, 2008, 11:59:42 am »
After I took some pictures of my new exhaust I noticed this in the picture, so I went under my Jeep and looked around and can't figure out where it goes. Maybe someone can help me out.
157
Technical Advice and Questions / Re: Idler Pulley Help
« on: April 19, 2008, 03:32:40 pm »
I believe you, but there wasn't anything like that on my block.
158
Technical Advice and Questions / Re: Idler Pulley Help
« on: April 18, 2008, 03:05:26 pm »
Is that picture upside down? If not it looks nothing like my motor.
159
Technical Advice and Questions / Idler Pulley Help
« on: April 17, 2008, 10:48:47 pm »
I have a 1989 Cherokee Sport 4.0L I got the old pull off but I cant get the new one on due to the belt not having enough play in it. And I can't seem to find the tensioner to loosen up the belt so I can slip it under the pulley. Any help on this matter would be nice. Thanks