Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Peyton

Pages: [1] 2 3 4
1
Technical Advice and Questions / Re: Motor stalls
« on: October 26, 2014, 01:51:20 pm »
Sorry for the delay thanks it was my ground. Thanks again

2
Technical Advice and Questions / Motor stalls
« on: September 30, 2014, 04:17:32 pm »
Ok everyone thanks for all the advice on my other problems.  I have everything working great but now When I'm at an idle and the electric fan comes on it stalls the motor. Its a new fan and a rebuilt alternator 104 amp. I'm stuck on this one any ideas

Thanks
Dave

3
Technical Advice and Questions / Re: Shop recommendations for gear work
« on: September 12, 2014, 02:56:11 pm »
Just got a price from hoaks $400 per axle not bad

4
Technical Advice and Questions / Dana 44
« on: September 12, 2014, 01:56:41 pm »
I need little help Will a 72 scout dana 44 fit a 85 cj 7.
Thanks
Dave

5
Technical Advice and Questions / Gas pressure
« on: July 18, 2014, 09:57:33 pm »
What's recommend gas pressure and timing  for cj 7
Thanks dave

6
Technical Advice and Questions / Re: Holly carb
« on: July 17, 2014, 12:17:10 pm »
Thanks

7
Technical Advice and Questions / Re: Won't go over 55 mph
« on: July 17, 2014, 12:15:47 pm »
No I'm only turning about 1700 rpm I'm thinking it may be my carb

8
Technical Advice and Questions / Re: Holly carb
« on: July 14, 2014, 05:33:01 pm »
Will it fit my 258

9
Technical Advice and Questions / Holly carb
« on: July 14, 2014, 10:31:14 am »
Does anyone know of a holly carb to replace my weber

10
Technical Advice and Questions / Re: Won't go over 55 mph
« on: July 14, 2014, 10:30:12 am »
Yes just no power after 55 below 55 it's good

11
Technical Advice and Questions / Won't go over 55 mph
« on: July 13, 2014, 05:56:17 am »
Anyone know why my cj 7 looses power at 55 mph I have 258 auto trans. Replaced all Spark plugs wires distributor cat and vacuum lines. I did leave vacuum advance n power boaster. I'm being told their should be one for trans but can't find one anywhere.
Thanks
Dave

12
PA Jeeps Membership / Re: Joining
« on: June 30, 2014, 01:11:48 pm »
Thanks I'll be there

13
Technical Advice and Questions / Painter
« on: June 30, 2014, 10:53:26 am »
Does anyone know of a good painter looking to get my cj done soon.

Thanks
Dave

14
PA Jeeps Membership / Joining
« on: June 30, 2014, 10:18:53 am »
Will I be able to join the club if I come to the July 11 th meeting?

15
Technical Advice and Questions / Re: Battery
« on: June 12, 2014, 08:17:48 am »
Thanks everyone for the info.

Pages: [1] 2 3 4