Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Leonard

Pages: [1]
1
General Discussion / Meeting this Friday?
« on: July 05, 2011, 11:57:34 am »
I just involuntarily changed jobs, so I should be able to make some of the meetings again.  Is there one this Friday or is it being skipped because of the show next week?

2
PA Jeeps Membership / Renewal rate question
« on: February 01, 2011, 05:18:28 pm »
Being the knucklehead that I am, I failed to send my renewal in BEFORE my membership expired, since it was my first year as a member, do I now pay the full price or the renewal price?  I am assuming it would be renewal, but just want to make sure before I send it.


3
Technical Advice and Questions / I have a leak
« on: August 03, 2010, 08:43:51 am »
I noticed it this morning, I think it's my outer seal gone bad on the passenger side, can somebody verify from this picture?
http://millerlw.multiply.com/photos/album/6

And I coud swear there used to be a piece of plastic, dirt guard, that used to sit in there someplace.

This pic isn't my axle, I found it on the internet.

Thaniks,
Leonard

4
Technical Advice and Questions / Manual Throttle install on YJ
« on: August 20, 2009, 07:04:05 pm »
Hi,
I am trying to install a manual throttle on my YJ, and I'm almost done, but I can't figure out how to get the cable to stay secure at the linkage.  I have the cable looped around the linkage and back thru the cable chip/clamp, parallel with itself, but I cannot get it to secure the two cables together.  Is the cable chip/clamp supposed to clamp around the two cables?  Or am I completely off on this one?  I tried to attach a picture of it from the manual, but apparently the upload folder is full and will not take my file.  sigh
This is the one I have and the instructions are there.  It's the second picture on the 3rd page of the install instructions.

Thanks in advance,
Leonard

Pages: [1]