Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Deadpool

Pages: [1]
1
General Discussion / Jeeper needs some help this weekend...
« on: October 19, 2012, 03:23:56 pm »
I need some assistance figuring out what's actually wrong with my front Dana 30 axle. i was told the locker is busted, but didn't confirm that myself. Unfortunately, I have no garage, and only hand tools to work with.

What I'm looking for is someone that can give me a hand with pulling this apart and seeing what is wrong, someplace to work, and assistance pulling the u-joints out of a set of Dana 30 front axles if there is something that can't be easily fixed to make the jeep drive-able.

I realize that this is short notice, and kinda fast. I just have been dealing with an issue with a local shop and if anyone wants to know about it, I'll fill them in. But if you can give me a call or text (717-307-8881) if you are able to give me a hand. I can drive it, just not daily. I'll be getting an inspection this weekend as well (went up last month, but has been in the shop and unmovable since the 17th of September).

Thank you and it's greatly appreciated!!!


If someone just tried to send me a PM, my work system won't let it go through. Send me a message here, or text my phone. I have it right beside me and I'll not be back here until later.

2
I got a set of stock Rubicon Flairs for my '98 TJ Sport. I like the wider flairs than the stock, and these are in better shape than my stock flairs. Here's the issue, I have only tried one fender (Front Passenger) but there is one of the bolts at the back of the flair by the door that is NOT removing. It's spinning with the bolt and I can't figure out how to lock it so that I can install the new fiairs. I'm going to check the other fender flairs to see if I'll have a similar issue with the other bolts.

Here's the question, what's the easiest way to install these new flairs if the existing bolts/screws are giving issues and have to be cut/drilled out? Is there any secret to get these installed even though they are stock, or is it just dumb luck if they'll install or not?

All help, suggestions, offerings of assistance is greatly appreciated.

Thank you,
Joe

Pages: [1]