Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Scott Drawbaugh

Pages: [1]
Monthly Meetings / Information / Re: Christmas Party /Meeting
« on: December 11, 2010, 02:38:43 pm »
We'll be there... Party sub tray

General Discussion / Re: What did you do to your Jeep today?
« on: October 16, 2009, 12:19:05 pm »
Very Nice...I tried to sneak in Hoaks for a preview, but Mike kicked my a** out...

Hey Nate
Call Rodney @ 717-764-1501. He is located in Dover, PA....He is all about Jeeps and nothing else......He is very reputable....

Technical Advice and Questions / Re: ZJ bumber
« on: March 31, 2009, 07:40:13 pm »
Are you looking for stock bumper? If so, I have a 96 limited edition shiny and black..Let me know....

Technical Advice and Questions / Re: 96 Grand Laredo Rear Diff
« on: July 31, 2008, 10:41:53 am »
44a L.S. (3.73) was factory in most of the V8 models, if the ZJ is a 4.0 six and has a 44a it was special order or upgraded by the previous owner

I was doing my T.C. drop today on my 96 zj, I was spraying the bolts with penetrating oil and noticed one of the cross member bolts was already loose. When I went to tighten the bolt, the nut was turning on the inside of the uni-body. Is there any solutions to this problem other than drilling a hole in the floor just above this problem nut so I can remove it, and install the new nut and bolt. The other 3 nuts are OK...Need any advice

I have the Rancho RS 9000 XL series adjustables, and they seem to perform great on and off pavement... The adjustability for condions is great, You can even mount an in the cab control for these shocks.... See the guys at Hoak's they are great...

Looking to swap my current 247/249 Qudra drive transfer case for a 242 select trac in my 1996 ZJ 5.2. Will this be a direct swap? or can I expect to do some mods to the input shaft of the transfer and drive shafts? any help or web links would greatly be a appreciated.

Pages: [1]