PA Jeeps

The Garage => Technical Advice and Questions => Topic started by: Leonard on August 20, 2009, 07:04:05 pm

Title: Manual Throttle install on YJ
Post by: Leonard on August 20, 2009, 07:04:05 pm

Hi,
I am trying to install a manual throttle on my YJ, and I'm almost done, but I can't figure out how to get the cable to stay secure at the linkage.  I have the cable looped around the linkage and back thru the cable chip/clamp, parallel with itself, but I cannot get it to secure the two cables together.  Is the cable chip/clamp supposed to clamp around the two cables?  Or am I completely off on this one?  I tried to attach a picture of it from the manual, but apparently the upload folder is full and will not take my file.  sigh
This is the one I have and the instructions are there.  It's the second picture on the 3rd page of the install instructions.

Thanks in advance,
Leonard

Title: Re: Manual Throttle install on YJ
Post by: Leonard on August 21, 2009, 03:22:55 pm

Ok, I finally got it after I sent the message.  Guess I just needed a break.