Author Topic: harmonic balnacer hitting water pump  (Read 5170 times)

jeepcj7304

  • Jr. Member
  • *
  • Posts: 60
    • View Profile
harmonic balnacer hitting water pump
« on: July 16, 2010, 07:03:59 pm »
I just got my rebuilt motor.  I bolted it all in and when i tried to install the harmonic balbancer it wont go on it is hitting the bottow of the water pump any ideas?

hillbilly

  • Hero Member
  • ****
  • Posts: 1491
  • adam lewis - appalachian american - B.O.D.
    • View Profile
Re: harmonic balnacer hitting water pump
« Reply #1 on: July 16, 2010, 10:09:12 pm »
what kind of motor? jeep show is this weekend you could stop by and check out the other jeeps for ideas.
build it, beat it, break it, fix it, repeat
A member of the church requests to be buried in his jeep because "It ain't never been in a hole it couldn't get out of."
   91 xj 8.5" lift -33" x 12.50 and my own additions
 94 xj (wifes) 3.5" lift and the boys 1979 cj7

jeepcj7304

  • Jr. Member
  • *
  • Posts: 60
    • View Profile
Re: harmonic balnacer hitting water pump
« Reply #2 on: July 17, 2010, 08:07:46 am »
y aill be there i was hoping to have my jeep there but not gonna happen it is a 360

jeepcj7304

  • Jr. Member
  • *
  • Posts: 60
    • View Profile
Re: harmonic balnacer hitting water pump
« Reply #3 on: July 17, 2010, 08:31:02 pm »
ok looks like i got it fixed.  I pulled the water pump and installed the harmonic balancer.  There is about a 1/8 of an inch of clearance between the timing cover and the balancer.  But the ones I saw today at the PA Jeep show looked really close too.  Then I clearanced the pump a little and test fit it.  It doesnt rub at all so just need to get a new gasket and put it all back together.  Then just pray it starts up and nothing leaks. fingers crossed.