PA Jeeps

The Garage => Technical Advice and Questions => Topic started by: Scott Drawbaugh on January 27, 2008, 01:48:33 pm

Title: Cross member bolts and welded frame nuts/96 zj
Post by: Scott Drawbaugh on January 27, 2008, 01:48:33 pm

I was doing my T.C. drop today on my 96 zj, I was spraying the bolts with penetrating oil and noticed one of the cross member bolts was already loose. When I went to tighten the bolt, the nut was turning on the inside of the uni-body. Is there any solutions to this problem other than drilling a hole in the floor just above this problem nut so I can remove it, and install the new nut and bolt. The other 3 nuts are OK...Need any advice

Title: Re: Cross member bolts and welded frame nuts/96 zj
Post by: cjbroke on January 28, 2008, 08:19:04 am

Or...you could cut it off and use a Nutsert.