Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 76cj7

Pages: 1 [2]
16
Technical Advice and Questions / Re: Windsheild
« on: December 18, 2010, 06:51:08 pm »
i was pritty shure plexi glass wasnt legal. a guy at work told me he used it on his little samari.It didnt seem real safe to me lol.

17
Technical Advice and Questions / Re: Windsheild
« on: December 14, 2010, 03:18:26 pm »
is it legal to use plexi glass? i work at hardware store and i could have one made.

18
Technical Advice and Questions / Re: Windsheild
« on: December 13, 2010, 05:30:44 pm »
cool i wasnt shure if a yj one word work...that will make it easyer... will one from a 59 cj5 work...i might be able to get one from that.

19
Technical Advice and Questions / Windsheild
« on: December 12, 2010, 09:41:26 pm »
does anyone have an extra windsheild for a cj7 that thay would sell? mine just broke for the second time.

20
Technical Advice and Questions / cj7 drive shaft
« on: November 21, 2010, 09:13:56 pm »
hi, i have a 1976 cj7 and i just put a 285 motor and a 4speed trans from a 1984 cj7 in to it and now i am having a hard time with finding the right drive shafts. Can anyone tell me if the 76 would have a diffrent size rear as the 84? Can i just use a set of 84 driveshafts?

21
Technical Advice and Questions / 4.0 exhaust manifold on a 4.2
« on: August 11, 2010, 10:43:00 pm »
can anyone tell me if a 4.0 exhaust manifold will fit on a 4.2...the 4.0 one looks like it would flow a lot better than my 4.2 on my cj7

22
Technical Advice and Questions / Re: yj floor pan replacement
« on: July 30, 2010, 10:25:13 pm »
yeah i just drilled out all the spot welds and took the old floor out today and the cj7 floor slips right in to place

23
Technical Advice and Questions / yj floor pan replacement
« on: July 29, 2010, 10:14:48 pm »
I was wondering if a 1988 yj would use the same floor pan as a cj7. I have a cj7 floor pan and my yj tub needs to be replaced. the tub is going on a 76 cj7.Also does anyone know of a good shop that would take on the job of replacing the floor for me? thanks

24
Technical Advice and Questions / Re: yj tub on a cj7 frame
« on: July 14, 2010, 07:22:02 pm »
ok thanks alot.ill be going to the show saterday. I found a yj tub for $500 but i just wanted to figure out what i was getting into before spending all the money.

25
Technical Advice and Questions / Re: yj tub on a cj7 frame
« on: July 13, 2010, 05:47:51 pm »
thanks for the link.it was very helpful

26
Technical Advice and Questions / Re: Stay SBC or go BBC
« on: July 12, 2010, 07:50:13 pm »
I would stay with the 350. you can do a lot to a small block chevy for cheep. I just got done puting one in my 77 buick regal and it didnt cost much and its got a LOT of power...plus its lighter :)

27
Technical Advice and Questions / yj tub on a cj7 frame
« on: July 12, 2010, 06:53:52 pm »
hi, i am new to jeeps and  i just bought a 1976 cj7 that needs a new tub. I have found a yj tub to put on the jeep but i was wondering how hard it would be to do this swap. Can some one tell me what all has to be done? I know the gas fill is on the other side and the tailgate its different.

thanks,Connor

Pages: 1 [2]