Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Leonard

Pages: 1 [2]
16
General Discussion / Re: What did you do to your Jeep today?
« on: April 21, 2010, 09:29:02 am »
PowerAid throttle body spacer, front and rear DayStar Rockcrusher Greaseable Shackles and Rough Country rear shocks.  Ordered a set of 35" BFG MTR KM2's, but they will not be available until june 14th.  JUNE 14TH!!!!! Thanks BFG for making me wait, losers.

17
General Discussion / Re: Famous and not so famous movie lines.
« on: February 09, 2010, 10:14:51 am »
Go ahead and age yourself with this, I'm throwing two in to make it easy.

What did you expect? "Welcome, sonny"? "Make yourself at home"? "Marry my daughter"? You've got to remember that these are just simple farmers. These are people of the land. The common clay of the new West. You know... morons.

Now I don't have to tell you good folks what's been happening in our beloved little town. Sheriff murdered, crops burned, stores looted, people stampeded, and cattle raped. The time has come to act, and act fast. I'm leaving.


18
General Discussion / Re: What did you do to your Jeep today?
« on: January 15, 2010, 02:30:02 pm »
Had a load test performed and found out yesterday that I need a new battery.  Gave Wobble a bath.   Bought a new serpentine belt to install this weekend.

So that's what was wrong with it?  Interesting....
Now that it's fixed, what's are you going to do it?

19
Technical Advice and Questions / Re: Manual Throttle install on YJ
« on: August 21, 2009, 03:22:55 pm »
Ok, I finally got it after I sent the message.  Guess I just needed a break.

20
Technical Advice and Questions / Manual Throttle install on YJ
« on: August 20, 2009, 07:04:05 pm »
Hi,
I am trying to install a manual throttle on my YJ, and I'm almost done, but I can't figure out how to get the cable to stay secure at the linkage.  I have the cable looped around the linkage and back thru the cable chip/clamp, parallel with itself, but I cannot get it to secure the two cables together.  Is the cable chip/clamp supposed to clamp around the two cables?  Or am I completely off on this one?  I tried to attach a picture of it from the manual, but apparently the upload folder is full and will not take my file.  sigh
This is the one I have and the instructions are there.  It's the second picture on the 3rd page of the install instructions.

Thanks in advance,
Leonard

Pages: 1 [2]